So… After a lot of testing… It’s been awhile since I’ve done a guide, and this one was a long time coming. This guide will allow you to do your entire project in Lightburn, and (if connected via USB) run it directly from Lightburn. Letting you skip Luban or using the USB drive entirely. A quick n…

If you reset, you have to go through the calibration first, then load the firmware.

Sure but for the calibration the module first has to work. damn :confused:

You mentioned an Artisan as well, can you hook the module up to the artisan and run the firmware update on it to update the module firmware? If that doesn’t work, you may need to contact support.

Yeah also tried this but wheater the SN2 nor the Artisan are able to fully control the module firmware now is on both modules :confused: seems i have to contact the support. Am I the only one with that problem? Are you able to go to the Snapmaker firmware from your custom one?

I’ve had no issue swapping back and forth, but it is no longer needed. You can run the firmware update on your machine alone without the 10W plugged in and it’ll update the controller fine. If you get it going again, make sure to just keep the latest firmware on the machine. @Zoe Is there any way y…

@Skreelink , I made it a wiki, so you should be able to edit it again :blush:.

Thank you, modified for clarity, and made a point to my newer guide for the IR/40W, which is technically an update to this guide and works with all the lasers.

ive been reading through this and it seems the more I read the more confusing it becomes. I Have the SM2.0 A350 with the 2W IR working in lightburn. This is loaded using the GRBL-M3 I am trying to get the rotary module setup Do I use the GRBL setup or the Marlin? Or the snapmaker Marlin? There s…

I think you have to go here: [image] Lightburn + Rotary Guide Snapmaker 2.0 This is going to be a quick guide on the settings/required modifications to use the rotary module with Lightburn. [PXL_20221222_205047036] I am sorry, but it will require following the beginning…

For the rotary you must use the Snapmaker Marlin and for the rotary take Chuck and B axis. Marlin inline (what I normaly use to laser) has no B axis option. Use the last Snapmaker Firmware. No others.

Full Lightburn Control Guide

Snapmaker 2.0 (3-in-1)

Skreelink January 25, 2026, 11:21pm 552

This is the guide you need for that. Keep in mind, this is untested with the “Marlin” or “Snapmaker” device profiles. I tend to stick with what I know works, so I haven’t tested either of those.

Topic		Replies	Views
1064nm IR+20/40W + Lightburn Guide Snapmaker 2.0 (3-in-1)	125	8084	April 29, 2026
Snapmaker 2.0 A350T and Lightburn Snapmaker Luban	112	3845	November 3, 2023
SM1 Laser (1600 mW) and working with Lightburn Snapmaker2.0 Troubleshooting guides	37	8565	October 2, 2020
Laser Pause While Changing Power Snapmaker 2.0 (3-in-1)	91	5503	May 26, 2021
Working camera capture with Lightburn Snapmaker 2.0 (3-in-1)	85	8488	June 14, 2026

Full Lightburn Control Guide

Related topics