Bed Leveling/Adhesion Issues for the Dual Extruder

[Hauke]

@Jameracho

I should also mention that I’m using the original Kickstarter bed frame, but the linear modules have been replaced with the latest models. @Mxbrnr mentioned in their post that the new bed frames likely have a better tolerance so I’ll reach out to Snapmaker and see if I can get a replacement.

@Jameracho

One thing I just realized is that my quick swap kit is coming soon which may completely change my situation.

If you ordered the Quick Swap Kit, you do not need to order a new bed frame! See here:

The long-awaited quick swap kit for Snapmaker 2.0 250/350 machines - Snapmaker 2.0 - Snapmaker: where creation happens

I did the same as @Wyphorn and moved the threaded insets from the kickstarter frame to the new frame, and you have your new 3D printing frame. I yet have to see if the improvement is enough to satisfy me (you can see in the thread I linked in that the results are not overwhelming from the pure measurements side, but how this translates into practical issues or not I need to test yet).