J1 seems to be prone to Layer Shifts

Snapmaker J1
1

I am not the only one who seems to be encountering this as others have reported in the Facebook profile. The J1 seems prone to layer shifting.

I have belts that are properly tensioned with the tensioning tool but I have encountered three different layer shifts in a span of a month of printing.

With my CR6-SE I have encountered a layer shift once in it’s two years of steady usage. I am not sure if this has to do with the motion architecture of the device or an untuned Cura profile, but it is wasteful to my time and to filament.

The most recent failed print was done with Polymaker PC-FR and Polymaker PolyDissolve S2. You will find a zipped version of the Cura profile attached.

Layer Shift
Layer Shift1920×1446 261 KB

pc-pva.curaprofile.zip (1006 Bytes)

2

Hi edgett, have you contacted our Support at support@snapmaker.com?

3

I had not, but just did.