Blockquote
For me this was the main point. You are not using your machine with the necessary care.
The machine is in good hands. Has plenty of space, a solid standing, room temperature, dry, no direct sunlight and hasen’t been moved or touched (beside filament change) sinse September 2022. The controller stopped working mid printing.
Blockquote
After the warranty period, they make a lot possible via support. So even individual parts that you can’t officially buy are often available on request for a reasonable price.
I have made that good experience.
Altough I had wished to have to parts working a bit longer than a few months after the waranty period.
Blockquote
Snapmaker could really do something about cable management, but only because it is chaotic and invites errors in assembly and less because it doesn’t do its job.
Voila…
Blockquote
All in all, I can’t agree with the points.
You don’t have to agree!
And I once was a very pro too. See here: Humble improvement ideas F350 (3D Print) - Snapmaker 2.0 - Snapmaker: where creation happens
But however, this isn’t a post about the good things: it is about my machine that obviously never was of strong health.