Hi all,
Having the clogging issue with my 3 months old Artisan. I managed to print a lot of parts, but my problems started when I printed a large piece (38 cm) and I got clogging for the first time. Now, I have this issue most of the time. I read for many hours the threads in the forum.
I disassembled the extruder to ensure it was not clogged with PLA.
I tested with CURA and Luban from the same part
I tried to lower the temperature from 215 to 205
I tried removing the door in from of the dual extruder unit, to have better flow.
I did not try the new door design, I cannot print anymore, so that would be hard!
I saw in the J1 forum side people re-designed the hot end to fix the issue!
I’m extremely disappointed, since everything was working fine for 2-3 months of usage, and now I cannot print anymore.
I think I will open a case with Snapmaker.