Improving Dimensional Accuracy

[brent113]

@Cao314159

is there a standard test print I should use?

Yes, I use Teaching Techs, my experiences with it and the machine are documented here:

Snapmaker 2.0 Initial Calibration Settings / Experiences

Hello all, I thought I’d type up my setup and calibration procedures for future reference since I haven’t seen too much of this information in a single place before. Hopefully this is useful. There are other introductory posts worth reading such as: @xchrisd’s 3d Print Guide_Walk Through The first thing I did was update to the latest firmware, change the auto bed levelling to 5x5 grid, and do an auto level. I’m impressed with this process, it works pretty smoothly. Looking ahead, I’ve fou…