Just my thoughts, not saying anything is right or wrong!
- I just gave my U1 a fixed port via my router so it never changes?
- figure the above covers this, but might not fully understand the advantages?
- I use adaptive bed meshing, so it meshes every print, BUT! only the area the print is going too so much quicker
- If you think that’s useful?
- I very much doubt you’ll get this as like all other firms they don’t want rivals seeing everything that’s going on!
- Yeah, good point liking this one muchy
- Could be useful for trouble shooting, but could cause some people to panic when not needed too resulting in not needed support requests (knowledge is a dangerous thing in the wrong hands)
As I said NOT diss’ing what you’ve said as its YOUR wishes, just adding a few thoughts 