INSTRUCTIONS:
I run this file when I first start up my Snapmaker. If the level seems good I will just continue on to printing. If a few points are off I will adjust them using a “Tweak Macro” which I set up in Luban and is easy and quick to update and execute. When I am adjusting the grid I use one of the following files to write down which points need to be adjusted:
If I’m doing a brand new level, I will do an Auto Level with a cold bed, record the matrix and then adjust it according to the heating curve I posted. Heating Curve link
Then I check the level again and make any adjustments to the matrix from there.