But why? "[I][PLAT]reset sys pos and WCO because disabling motor [I][PLAT]reset coordoffset"

[Skreelink]

@xchrisd

Anyway, I would suggest to set it up like in the lightburn guide

Just so you know, I have an updated guide. It was specifically for the IR, but it works flawlessly with the 40W as well, and the other lasers as long as you get your initial focus height correct.

1064nm IR+20/40W + Lightburn Guide

With the new IR laser coming out, I figured testing and guides would follow. Lucky enough, it seems with minimal tweaks, Lightburn works with the new IR just fine. So here’s a guide on setting it up fully with Lightburn for auto-focusing and accurate results. Note; while I don’t have the 20/40W lasers, this guide SHOULD work for those as well. CONFIRMED WITH 40W I tested both USB connection, and using my Drag/Drop files I - Gathering Information You’ll need to find out homing pl…