Hi all , I’m a newbie of 3 modules of SnapMaker . Once I tried to mill a PCB with CNC module , then left side of PCB was dug deeply and right side was shallowly . I thought the CNC module didn’t have well level against to the bed . It’s difficult for me to adjust level the CNC module every time …

The silence is deafening with this problem. Any luck figuring this out?

CNC module leveling

Jade November 8, 2018, 2:34am 3

just top up the discussion in another similar topic in this forum Non-level CNC bed?

Topic		Replies	Views
Bed leveling for pcb milling? Original (3-in-1)	34	6234	February 20, 2025
Bed levelling after CNC or Laser module? Snapmaker 2.0 (3-in-1)	9	1450	November 30, 2020
Levelling the Bed for CNC Carving and Laser Engraving Snapmaker2.0 Troubleshooting guides	3	1727	June 27, 2018
CNC mode, z axis levelling Snapmaker 2.0 (3-in-1)	2	555	February 14, 2023
CNC Bed Leveling Snapmaker 2.0 (3-in-1)	4	1147	June 6, 2022