# Worked so well yesterday - woke up to this

**URL:** <https://forum.snapmaker.com/t/worked-so-well-yesterday-woke-up-to-this/9746>\
**Category:** Snapmaker 2.0 (3-in-1)\
**Created:** [September 24, 2020, 5:56am UTC](https://forum.snapmaker.com/t/worked-so-well-yesterday-woke-up-to-this/9746 "2020-09-24T05:56:23Z")\
**Posts on this page:** 1\
**Showing post:** 8

<div class="post-metadata">

**Author:** ![xchrisd](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.snapmaker.com/xchrisd/32/1503_2.png) [@xchrisd](https://forum.snapmaker.com/u/xchrisd)\
**Post date:** [October 2, 2020, 8:30am UTC](https://forum.snapmaker.com/t/worked-so-well-yesterday-woke-up-to-this/9746/8 "2020-10-02T08:30:06Z")

</div>

You did your first vase wrong.- At a vase there is no z-hop necessary. If you print with the right profile:

 ![image](https://us1.discourse-cdn.com/flex022/uploads/snapmaker/original/2X/e/e5353827e1c0bdd5aacc45688a4ed7eb75561e40.png)  
there is no infill and no travels which caused your print to hop off.  
Alternatively you could make a custom profile, where you activate the surface mode.

---

_[View the full topic](https://forum.snapmaker.com/t/worked-so-well-yesterday-woke-up-to-this/9746)._