# Very rough 1ste layer

**URL:** <https://forum.snapmaker.com/t/very-rough-1ste-layer/26888>\
**Category:** Snapmaker2.0 Troubleshooting guides\
**Created:** [August 1, 2022, 4:24pm UTC](https://forum.snapmaker.com/t/very-rough-1ste-layer/26888 "2022-08-01T16:24:33Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![CrazyPilot64](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.snapmaker.com/crazypilot64/32/19104_2.png) [@CrazyPilot64](https://forum.snapmaker.com/u/CrazyPilot64)\
**Post date:** [August 1, 2022, 4:24pm UTC](https://forum.snapmaker.com/t/very-rough-1ste-layer/26888/1 "2022-08-01T16:24:33Z")

</div>

![left](https://us1.discourse-cdn.com/flex022/uploads/snapmaker/original/3X/7/4/74bb2b59be167bb3942e2758814e589c256d39d5.jpeg)  
My first layer (bottom of the print) is very rough. 1st Layer on heated table, Al other sides are printed smoothly

What settings are requred to print a smooth botton?

---

<div class="post-metadata">

**Author:** ![ElloryJaye](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.snapmaker.com/elloryjaye/32/13979_2.png) [@ElloryJaye](https://forum.snapmaker.com/u/ElloryJaye)\
**Post date:** [August 1, 2022, 5:51pm UTC](https://forum.snapmaker.com/t/very-rough-1ste-layer/26888/2 "2022-08-01T17:51:33Z")

</div>

Looks like poor adhesion—most likely you’re printing just a smidge too high off the bed. Adjust the nozzle downwards a little bit and try again.