# Unable to get ANY PETG results

**URL:** <https://forum.snapmaker.com/t/unable-to-get-any-petg-results/14044>\
**Category:** Snapmaker 2.0 (3-in-1)\
**Created:** [January 6, 2021, 11:49pm UTC](https://forum.snapmaker.com/t/unable-to-get-any-petg-results/14044 "2021-01-06T23:49:57Z")\
**Posts on this page:** 1\
**Showing post:** 55

<div class="post-metadata">

**Author:** ![xchrisd](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.snapmaker.com/xchrisd/32/1503_2.png) [@xchrisd](https://forum.snapmaker.com/u/xchrisd)\
**Post date:** [March 20, 2021, 10:17am UTC](https://forum.snapmaker.com/t/unable-to-get-any-petg-results/14044/55 "2021-03-20T10:17:43Z")

</div>

Search the forum for PETG and you will get a lot of results and also settings.

Have a look at this comparison of 3d printing materials:

> [@Useful PETG guide](https://forum.snapmaker.com/t/useful-petg-guide/2685/22):
>
> No modifications needed. Don’t know PLA flex but PETG is similar to ABS but easier to handle. Please have a look at following table: [https://www.simplify3d.com/support/materials-guide/properties-table/](https://www.simplify3d.com/support/materials-guide/properties-table/)

I normally use this settings:

Heated Bed : 80°C  
Nozzel Temp: 235°C-250°C  
First Layer Speed: 8-15mm/s  
First Layer Height: 0,2mm  
Printing Speed: 30-50mm/s  
Layer Height: 0,2mm

---

_[View the full topic](https://forum.snapmaker.com/t/unable-to-get-any-petg-results/14044)._