# Trying to level my bed without the touchscreen and more issues **URL:** \ **Category:** Original (3-in-1)\ **Created:** [January 12, 2023, 9:27pm UTC](https://forum.snapmaker.com/t/trying-to-level-my-bed-without-the-touchscreen-and-more-issues/28955 "2023-01-12T21:27:04Z")\ **Posts on this page:** 1\ **Showing post:** 2
**Author:** ![Riskey](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.snapmaker.com/riskey/32/20010_2.png) [@Riskey](https://forum.snapmaker.com/u/Riskey)\ **Post date:** [January 13, 2023, 2:56am UTC](https://forum.snapmaker.com/t/trying-to-level-my-bed-without-the-touchscreen-and-more-issues/28955/2 "2023-01-13T02:56:49Z")
You could try the solution in these threads and see if they works for you: > [@Touchscreen failure, need to level bed to use luban](https://forum.snapmaker.com/t/touchscreen-failure-need-to-level-bed-to-use-luban/28470/2): > > You can use the Console and Control panel on Luban to level your heated bed (5×5 Auto Mode) by the following steps: Connect the machine with Luban via the USB cable. On the Console panel, enter G1029 P5. Enter G1029 A. The auto-leveling process will start. After the leveling process ends and the toolhead stops moving, adjust the height of the toolhead with the Z+ and Z- buttons on the Control panel and calibrate the Z offset with the provided calibration card or a piece of A4 paper (as instruc… > [@Calibrating with the console without a display](https://forum.snapmaker.com/t/calibrating-with-the-console-without-a-display/28945): > > Just posting it here for someone to download. This is the way to auto calibrate via the console if your display is broken. [Auto Calibration with more points.docx](https://forum.snapmaker.com/uploads/short-url/twBm3wBySWcuLwkgOiehNMeRObH.docx) (795.2 KB) --- _[View the full topic](https://forum.snapmaker.com/t/trying-to-level-my-bed-without-the-touchscreen-and-more-issues/28955)._