# Targeting Cross Hairs **URL:** \ **Category:** Ray (Laser)\ **Created:** [April 9, 2024, 2:53pm UTC](https://forum.snapmaker.com/t/targeting-cross-hairs/35545 "2024-04-09T14:53:47Z")\ **Posts on this page:** 1\ **Showing post:** 4
**Author:** ![ku3](https://avatars.discourse-cdn.com/v4/letter/k/e8c25b/32.png) [@ku3](https://forum.snapmaker.com/u/ku3)\ **Post date:** [April 10, 2024, 5:20am UTC](https://forum.snapmaker.com/t/targeting-cross-hairs/35545/4 "2024-04-10T05:20:32Z")
An offset in Y direction would be normal but as far as I know the crosshair pointer has no offset in X direction… So actually I don’t think this is the source of the problem. I’m using Lightburn but as far as I remember Luban is a bit special when you set the work origin - maybe you have to use some other setting there - have a look at [Snapmaker Ray 40W work origin problem](https://forum.snapmaker.com/t/snapmaker-ray-40w-work-origin-problem/34453) . Otherwise give Lightburn a try (30 day free trial) and see if the problem is the same wheb using this software. The Lightburn settings are downloadable at the Snapmaker Wiki… --- _[View the full topic](https://forum.snapmaker.com/t/targeting-cross-hairs/35545)._