If there any information available about the enclosure door switch pin-out as I want to sense the switch state to turn on internally mounted LED light strips when a door opens.
I’m making a Y-splitter cable to tap into the door switch cable and then I can check what happens, but it is always good to have official information to cross-check against.
Regards,
Mark
The pin definition for the switch on the enclosure for the Original is Limit Switch + and Limit Switch -.
Thanks for the response, however, I was actually wanting the pinout of the connector on the cable to the printer as a cross check.
Here is a diagram and a picture of the pinout. The first and third pins (Z Stop and GND) are what you need 
Thanks for the info.
Regards,
Mark