# Snapmaker Orca V1.1.0 Beta: Issues Report & Discussions **URL:** \ **Category:** Snapmaker Orca\ **Created:** [November 26, 2024, 10:19am UTC](https://forum.snapmaker.com/t/snapmaker-orca-v1-1-0-beta-issues-report-discussions/38235 "2024-11-26T10:19:38Z")\ **Posts on this page:** 1\ **Showing post:** 28
**Author:** ![highpower](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.snapmaker.com/highpower/32/15905_2.png) [@highpower](https://forum.snapmaker.com/u/highpower)\ **Post date:** [February 18, 2025, 9:09pm UTC](https://forum.snapmaker.com/t/snapmaker-orca-v1-1-0-beta-issues-report-discussions/38235/28 "2025-02-18T21:09:47Z")
I’m trying this out and printing this model. [https://makerworld.com/en/models/398058](https://makerworld.com/en/models/398058), imported the model, added two tabs for adhesion for the wings and adjusted the printing temperature based on the material. However, it seems the hotend started digging into the model since the second layer. I checked the gcode, it seems to be correct Z height: first layer .3, second layer .5, third layer .7 etc. Not sure what is lowering the Z height It even get into a point that the head is to low, that right nozzle is dragging on the bed (means the left nozzle has been pressed down). The result could be worse if my kids didn’t tell me. I tried loading the gcode into luban, and luban stopped after machine start up gcode. I need more time to troubleshoot this, which I don’t have right now, so reverting back to Cura. However, uploading the gcode here if someone can take a look: [https://drive.google.com/file/d/17DOaLKsPItMKounVGzNqkSe07fqm0VWX/view?usp=drive\_link](https://drive.google.com/file/d/17DOaLKsPItMKounVGzNqkSe07fqm0VWX/view?usp=drive_link) It is for Snampaker 2.0 AT350 with bracing and quick swap --- _[View the full topic](https://forum.snapmaker.com/t/snapmaker-orca-v1-1-0-beta-issues-report-discussions/38235)._