# Snapmaker Artisan not found by Orca Slicer

**URL:** <https://forum.snapmaker.com/t/snapmaker-artisan-not-found-by-orca-slicer/41471>\
**Category:** Snapmaker Orca\
**Created:** [March 14, 2026, 1:56pm UTC](https://forum.snapmaker.com/t/snapmaker-artisan-not-found-by-orca-slicer/41471 "2026-03-14T13:56:42Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![spucky](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.snapmaker.com/spucky/32/25910_2.png) [@spucky](https://forum.snapmaker.com/u/spucky)\
**Post date:** [March 14, 2026, 1:56pm UTC](https://forum.snapmaker.com/t/snapmaker-artisan-not-found-by-orca-slicer/41471/1 "2026-03-14T13:56:42Z")

</div>

Continuing the discussion from [Snapmaker Artisan Firmware Updates and Downloads](https://forum.snapmaker.com/t/snapmaker-artisan-firmware-updates-and-downloads/29975/22)

Hi everyone,

according to the announcement for the new FW V2.8.0 the Artisan should be recognized by Orca Slicer if both are in the same network. FW was installed a few days ago once it became available.

But that connection isn’t working for me. All devices are in the same network. I can ping the printer and I can send files directly via Luban or Cura.  
But the latest version of Orca Slicer (Beta V2.2.4-2) isn’t recognizing the device.

Orca Slicer is installed on Arch Linux, same install where Luban and Cura are working and connecting fine.

Any thoughts about how to fix it?

---

<div class="post-metadata">

**Author:** ![spucky](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.snapmaker.com/spucky/32/25910_2.png) [@spucky](https://forum.snapmaker.com/u/spucky)\
**Post date:** [March 15, 2026, 12:06pm UTC](https://forum.snapmaker.com/t/snapmaker-artisan-not-found-by-orca-slicer/41471/2 "2026-03-15T12:06:39Z")

</div>

Got it sorted.

In the dialog for network connectivity i’ve forgotten to enter the port after the IP adress.