Jan 22 2024: Snapmaker Artisan V2.5.23
Changelog
Touchscreen
New Features
- Added Laser Shot Output Power Settings support
- In this update, you can use Laser Shot Output Power Settings for fixing the 10W Laser Module which did not show laser indicator in Laser Job Preparation
- You can change the settings via Settings > Maintenance > Laser Calibration Parameters > Laser Shot Output Power
Bug Fixes
- Fixed a bug that Touchscreen would skip module update procedure on boot up check in some scenario
- Fixed a bug that laser spot would turn off in 10W Laser Job Preparation in some scenario
Mainboard
New Features
- Added Laser Shot Output Power Settings support
Bug Fixes
- Fixed a bug that X/Y will shift when starting a print job with 20W/40W Laser in some scenario
- When starting a new print job in Touchscreen, X/Y will shift when executing G-code(mainly generated by LightBurn) which was using relative mode
Module
New Features
- Added Laser Shot Output Power Settings support
Downloads
md5: 520cc674c0b56d3742708bfb00ea9c20