Hey guys,
I’d love to see your large prints.
I’ll start by sharing mine—looking forward to seeing yours! 
Here is a large print I did on the A350T for Escaped In Time escape room in Colorado Springs. It’s a Tinman bust from the Wizard of Oz movie.
Not fitting in one go actually!
Just before glue.
Hit with a layer of sandable primer, and after the first sand. Sent it off for them to paint after this!
5 Likes
This was the biggest print of my a150:
Not very big, but with quickswap and dual head the a150 is limited in height. Despite this, I print 90% of my models in that machine.
5 Likes
The largest print I’ve ever done on my Snapmaker is in fact my entry for the Print and Play Challenge held here from a couple of months ago. I only have an A150 so I’m limited to how large I can print, but I think I made good use of the space available.
5 Likes
Part of my son’s King Arthur costume from Halloween last year.
The shield is actually printed in two parts as it was too tall even for the A350T to print all at once. The lions and handle on the back were also printed separatly. Once printed we sanded, filled and spray painted.
We also printed a crown, sword, and chainmail.
3 Likes
My biggest print until now is a dice tower which also was my very first try to print something. Made with the black filament which was shipped with my A350T.
This is the result:
https://www.printables.com/de/model/851935-dice-tower-castle-stairs/comments/1825275
2 Likes