# Reusing broken print sheet?

**URL:** <https://forum.snapmaker.com/t/reusing-broken-print-sheet/20485>\
**Category:** Snapmaker 2.0 (3-in-1)\
**Created:** [August 19, 2021, 7:03am UTC](https://forum.snapmaker.com/t/reusing-broken-print-sheet/20485 "2021-08-19T07:03:27Z")\
**Posts on this page:** 1\
**Showing post:** 4

<div class="post-metadata">

**Author:** ![brvdboss](https://avatars.discourse-cdn.com/v4/letter/b/9f8e36/32.png) [@brvdboss](https://forum.snapmaker.com/u/brvdboss)\
**Post date:** [August 29, 2021, 1:08pm UTC](https://forum.snapmaker.com/t/reusing-broken-print-sheet/20485/4 "2021-08-29T13:08:21Z")

</div>

> [@dstarke](#):
>
> So I was wondering if I could recycle my broken Snapmaker 2.0 A350 print sheet by peeling off the plastic from the steel. Has anyone done this before? What would be a good way to do so? Or is this nearly impossible to get done right?

I think it’s doable. I recently peeled off one side because mine started showing bubbles and that worked. It wasn’t super easy and took some time, especially to get the remaining glue off.  
You can see some pictures here:

> [@Print sheet coating getting loose (bubbles)](https://forum.snapmaker.com/t/print-sheet-coating-getting-loose-bubbles/20625/5):
>
> I haven’t yet. I actually kinda like the spring steel bed. I love how a print just pops off as you bend it slight_smile And also as I kinda like using PETG, I would still need to cover the glass with something to avoid it destroying the glass. Doing a first print (PETG) on the cleaned bed now. Some pictures: After peeling of the cover. I used a scalpel to cut through the glue as I was peeling. this did leave some marks on the steel sheet. (there is still a paint layer or something.

I started peeling it off from a corner (had the bed heated) that seemed to make it go easier. I used a scalpel to cut the glue loose at first, but that did scratch the surface somewhat. So better be careful to nut cut into the plate while doing that.

After that I took it outside and used a lot of sticker remover and a glass scraper to get all the glue residue off. It might also work if you start peeling it off to get some sticker remover in between to soak it off.

So is it possible, yes. It did take me 1h30 to 2h to get one side off completely and cleaned. Once you start with the sticker remover, make sure you can do that outside or at least near an open window and that you have a flat surface to work on. (and that won’t get damaged by the sticker remover)

---

_[View the full topic](https://forum.snapmaker.com/t/reusing-broken-print-sheet/20485)._
