# Resolved: Octoprint swallowing extruder switch commands

**URL:** <https://forum.snapmaker.com/t/resolved-octoprint-swallowing-extruder-switch-commands/38270>\
**Category:** Third Party Software\
**Created:** [November 28, 2024, 2:23pm UTC](https://forum.snapmaker.com/t/resolved-octoprint-swallowing-extruder-switch-commands/38270 "2024-11-28T14:23:23Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![profhenning](https://avatars.discourse-cdn.com/v4/letter/p/779978/32.png) [@profhenning](https://forum.snapmaker.com/u/profhenning)\
**Post date:** [November 28, 2024, 2:23pm UTC](https://forum.snapmaker.com/t/resolved-octoprint-swallowing-extruder-switch-commands/38270/1 "2024-11-28T14:23:23Z")

</div>

Finally I could no longer control my desire for the dual extruder module. And run into a problem immediately:

Given a nice two-color (or two-material) model I have tried two workflows

1. Slice with Luban, export to A350 via WLAN, start ==\> printing is ok, both extruders are used.

2. Slice with Luban, export to gcode file. Load gcode file into Octoprint, let Octoprint control the A350. ==\> printing is done only with the first extruder.

Apparently Octoprint swallows/removes/ignores the gcode to switch extruders. Which I find annoying, because Octoprint works nicely for controlling the printer. I assume that some gcode editing coul solve the problem - has anybody ever attempted this?

Regards

pah

---

<div class="post-metadata">

**Author:** ![Tomi](https://avatars.discourse-cdn.com/v4/letter/t/f4b2a3/32.png) [@Tomi](https://forum.snapmaker.com/u/Tomi)\
**Post date:** [November 28, 2024, 3:09pm UTC](https://forum.snapmaker.com/t/resolved-octoprint-swallowing-extruder-switch-commands/38270/2 "2024-11-28T15:09:49Z")

</div>

Hi @profhenning  
Did you read this post :  
[A350T + DualExtruder + Octoprint - Snapmaker 2.0](https://forum.snapmaker.com/t/a350t-dualextruder-octoprint/32248/9)

---

<div class="post-metadata">

**Author:** ![profhenning](https://avatars.discourse-cdn.com/v4/letter/p/779978/32.png) [@profhenning](https://forum.snapmaker.com/u/profhenning)\
**Post date:** [November 28, 2024, 3:43pm UTC](https://forum.snapmaker.com/t/resolved-octoprint-swallowing-extruder-switch-commands/38270/3 "2024-11-28T15:43:11Z")

</div>

No, I did not find in the search. Thank you, excellent, trivial solution!

Regards

pah
