# Reset to factory settings?

**URL:** <https://forum.snapmaker.com/t/reset-to-factory-settings/23058>\
**Category:** Snapmaker 2.0 (3-in-1)\
**Created:** [December 29, 2021, 9:01pm UTC](https://forum.snapmaker.com/t/reset-to-factory-settings/23058 "2021-12-29T21:01:10Z")\
**Posts on this page:** 1\
**Showing post:** 3

<div class="post-metadata">

**Author:** ![CNC-Maker](https://avatars.discourse-cdn.com/v4/letter/c/df788c/32.png) [@CNC-Maker](https://forum.snapmaker.com/u/CNC-Maker)\
**Post date:** [September 6, 2022, 6:02am UTC](https://forum.snapmaker.com/t/reset-to-factory-settings/23058/3 "2022-09-06T06:02:40Z")

</div>

To perform a **Full Factory Reset** to the currently installed version of firmware, you need to **Factory Reset** both the **Touch Pad** and the **Controller** :

1. Connect your computer to the **Controller** via USB (must be USB).
2. Issue an `M502` factory reset to the **Controller**.
3. Put the **Touch Pad** into **Developer Mode**. This is done via the **About** page, and tapping the printer image 5 times. You’ll see a popup window when it changes modes.
4. Reset and clear out the **Touch Pad**. You will need to navigate around to find this, as it seems to change with each version of firmware.
5. Reinstall the currently installed version of firmware from a USB drive (must be from a USB drive). All versions of the firmware are available in the [Snapmaker 2.0 Firmware Updates and Downloads](https://forum.snapmaker.com/t/snapmaker-2-0-firmware-updates-and-downloads/5443) thread.
6. Update all of the modules.

---

_[View the full topic](https://forum.snapmaker.com/t/reset-to-factory-settings/23058)._