# Re-adjustment flat level of x-axis, if you hit the table **URL:** \ **Category:** Snapmaker 2.0 (3-in-1)\ **Created:** [May 13, 2021, 8:33am UTC](https://forum.snapmaker.com/t/re-adjustment-flat-level-of-x-axis-if-you-hit-the-table/18634 "2021-05-13T08:33:37Z")\ **Posts on this page:** 1\ **Showing post:** 7
**Author:** ![sdj544](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.snapmaker.com/sdj544/32/11365_2.png) [@sdj544](https://forum.snapmaker.com/u/sdj544)\ **Post date:** [May 14, 2021, 3:25am UTC](https://forum.snapmaker.com/t/re-adjustment-flat-level-of-x-axis-if-you-hit-the-table/18634/7 "2021-05-14T03:25:23Z")
No need for dial gauge . See post 34: > [@Carriage Tolerances - Unusable Over Distance \>75mm From Center](https://forum.snapmaker.com/t/carriage-tolerances-unusable-over-distance-75mm-from-center/10706/34): > > Just thought I’d share a picture of how I tram X now. This is fast and precise to do before I turn the machine on and home. Yesterday I deliberately left it 0.01mm low on the close side, and I could easily slide the far block under X, but the close side was too tight and the block hit the side. On the touchscreen I raised the Z height by 0.1mm and was easily able to slide both blocks in. Not making any claims on exactly how precise this is, as I’m aware of a slight rotation in the Y m… He’s using engineering blocks but any two things of the same size (soup cans, coke cans have close enough tolerances) will work. -S --- _[View the full topic](https://forum.snapmaker.com/t/re-adjustment-flat-level-of-x-axis-if-you-hit-the-table/18634)._