# Problems with Dual Extruder **URL:** \ **Category:** Snapmaker 2.0 (3-in-1)\ **Created:** [June 6, 2023, 7:10pm UTC](https://forum.snapmaker.com/t/problems-with-dual-extruder/31680 "2023-06-06T19:10:02Z")\ **Posts on this page:** 1\ **Showing post:** 6
**Author:** ![xchrisd](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.snapmaker.com/xchrisd/32/1503_2.png) [@xchrisd](https://forum.snapmaker.com/u/xchrisd)\ **Post date:** [June 7, 2023, 6:28pm UTC](https://forum.snapmaker.com/t/problems-with-dual-extruder/31680/6 "2023-06-07T18:28:49Z")
Hope this helps: Wedge: > [@\[First Batch Shipped Out\] FAQs of Dual Extrusion 3D Printing Module for Snapmaker 2.0](https://forum.snapmaker.com/t/first-batch-shipped-out-faqs-of-dual-extrusion-3d-printing-module-for-snapmaker-2-0/27340/109): > > Hallo, @brewery.chump0x Klar teile ich es mit Dir / Euch. Anbei die STL und Auszüge aus der Mail vom Support an mich. Grüße —————————————- Hello, @brewery.chump0x Of course I share it with you. Attached is the STL and excerpts from the email from support to me. Greetings [Block.stl](https://forum.snapmaker.com/uploads/short-url/8a8NaInmjOtKXbU6GoNqt2mv3nR.stl) (158.2 KB) Dualextruder Door: > [@Dual Extrusion Head: Heat creep discussion thread](https://forum.snapmaker.com/t/dual-extrusion-head-heat-creep-discussion-thread/30010/114): > > Hi all, so finally got around trying the new door design, and it was a full success! The model that failed after less than 20 mins before, now went through in 7 hours. The filament does not show any hint of broadening/heat creep, neither on left nor on right nozzle. Already informed support about the success, now waiting patiently for what they make from it - my assumption is that they’ll release a new front door and send this to those affected. I am curious how many this might be - would you m… --- _[View the full topic](https://forum.snapmaker.com/t/problems-with-dual-extruder/31680)._