# Printing with ABS - how many people use it and issues? **URL:** \ **Category:** Snapmaker 2.0 (3-in-1)\ **Created:** [August 26, 2020, 11:34am UTC](https://forum.snapmaker.com/t/printing-with-abs-how-many-people-use-it-and-issues/8657 "2020-08-26T11:34:52Z")\ **Posts on this page:** 1\ **Showing post:** 32
**Author:** ![xchrisd](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.snapmaker.com/xchrisd/32/1503_2.png) [@xchrisd](https://forum.snapmaker.com/u/xchrisd)\ **Post date:** [April 9, 2021, 7:25pm UTC](https://forum.snapmaker.com/t/printing-with-abs-how-many-people-use-it-and-issues/8657/32 "2021-04-09T19:25:24Z")
Maybe your filament is old or wet or printed too cold. There could also a mechanical cause, does it also break at the first 50layers? This is what I think about, maybe layer adhesion could get lost: > [@A350 Bed rises and falls even during slow speeds](https://forum.snapmaker.com/t/a350-bed-rises-and-falls-even-during-slow-speeds/6163): > > [Here is a video.](https://youtu.be/YBMUMF7F9NI) Watch the corner against the Z arm, and it’s quite noticeable it goes up and down. Am I the only one seeing this? May you share your gcode and model, it could even be a Slicer issue… --- _[View the full topic](https://forum.snapmaker.com/t/printing-with-abs-how-many-people-use-it-and-issues/8657)._