# Prime Tower

**URL:** <https://forum.snapmaker.com/t/prime-tower/44114>\
**Category:** U1 Toolchanger\
**Created:** [November 6, 2026, 10:50pm UTC](https://forum.snapmaker.com/t/prime-tower/44114 "2026-11-06T22:50:16Z")\
**Posts on this page:** 4\
**Page:** 1

<div class="post-metadata">

**Author:** ![Gramps-Too](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.snapmaker.com/gramps-too/32/30364_2.png) [@Gramps-Too](https://forum.snapmaker.com/u/Gramps-Too)\
**Post date:** [November 6, 2026, 10:50pm UTC](https://forum.snapmaker.com/t/prime-tower/44114/1 "2026-11-06T22:50:16Z")

</div>

IN Snapmaker Orca v2.4.1 the devs moved the prime tower from the left rear to left center. In it’s new location the prime tower now blocks the air flow from the side part cooling fan. I don’t know what the reason for moving it but it appears that the devs didn’t think it through. It’s kind of a pain to have to remember to move it each time you print.

---

<div class="post-metadata">

**Author:** ![KCC\_703](https://avatars.discourse-cdn.com/v4/letter/k/dfb087/32.png) [@KCC\_703](https://forum.snapmaker.com/u/KCC_703)\
**Post date:** [November 6, 2026, 11:55pm UTC](https://forum.snapmaker.com/t/prime-tower/44114/2 "2026-11-06T23:55:02Z")

</div>

I’ve gotten into the habit of moving it to the front corner… away from the aux fan, away from the docking. I suppose front center would be optimal if you need to see monitor it better…

---

<div class="post-metadata">

**Author:** ![RepairAndTinker](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.snapmaker.com/repairandtinker/32/32623_2.png) [@RepairAndTinker](https://forum.snapmaker.com/u/RepairAndTinker)\
**Post date:** [November 7, 2026, 6:38am UTC](https://forum.snapmaker.com/t/prime-tower/44114/3 "2026-11-07T06:38:15Z")

</div>

For me personally I don’t mind as I always move the wipe tower to a suitable location. I like to have it in between the tools used and the print location to minimize travel distances but also move it as close to the print as is physically possible to make sure there’s the least amount of stringing between wipe tower and print.

---

<div class="post-metadata">

**Author:** ![ColdCoffee](https://avatars.discourse-cdn.com/v4/letter/c/b9e5f3/32.png) [@ColdCoffee](https://forum.snapmaker.com/u/ColdCoffee)\
**Post date:** [November 7, 2026, 10:33am UTC](https://forum.snapmaker.com/t/prime-tower/44114/4 "2026-11-07T10:33:49Z")

</div>

I have always relocated the prime tower to where I want it as it depends on what is being printed and who much of the build plate it requires?
