# Preset save in software (laser)

**URL:** <https://forum.snapmaker.com/t/preset-save-in-software-laser/5313>\
**Category:** Snapmaker2.0 Troubleshooting guides\
**Tags:** Bug-report, Feature-Request\
**Created:** [February 17, 2020, 5:40am UTC](https://forum.snapmaker.com/t/preset-save-in-software-laser/5313 "2020-02-17T05:40:53Z")\
**Posts on this page:** 1\
**Showing post:** 4

<div class="post-metadata">

**Author:** ![Skreelink](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.snapmaker.com/skreelink/32/16398_2.png) [@Skreelink](https://forum.snapmaker.com/u/Skreelink)\
**Post date:** [November 1, 2024, 11:33am UTC](https://forum.snapmaker.com/t/preset-save-in-software-laser/5313/4 "2024-11-01T11:33:48Z")

</div>

If you have Lightburn and use a repeatable origin (basically making a hard corner to put your projects in) you can follow my guide. My workflow pretty much consists of just measuring my material, throwing it on the bed in the corner, doing a small ‘sketch’ in lightburn to represent my material, do up the project, export the gcode file, and drag/drop onto my sender file and off it goes all automagically. If I want to repeat a project, I just drag/drop the same gcode file and it does the exact same thing.

> [@1064nm IR+20/40W + Lightburn Guide](https://forum.snapmaker.com/t/1064nm-ir-20-40w-lightburn-guide/35954):
>
> With the new IR laser coming out, I figured testing and guides would follow. Lucky enough, it seems with minimal tweaks, Lightburn works with the new IR just fine. slight_smile So here’s a guide on setting it up fully with Lightburn for auto-focusing and accurate results. Note; while I don’t have the 20/40W lasers, this guide SHOULD work for those as well. CONFIRMED WITH 40W I tested both USB connection, and using my [Drag/Drop files](https://forum.snapmaker.com/t/guide-automatic-start-via-drag-drop/29177) I - Gathering Information You’ll need to find out homing pl…

Here’s some new updated corners that are more reliable as well for setting origin;

> [@Updated Laser Corners](https://forum.snapmaker.com/t/updated-laser-corners/37060):
>
> Finally got around to modeling up my own corners for laser alignment. These are more dependable and repeatable than the other ones I remixed and have been using. Figured I’d toss them here on the forums for others to use and so I can recommend them in my laser guides. Keep in mind I made the tolerances quite tight because of the friction fit, you may have to tune your printer to get them to fit properly. A350/T Version; A250/T With Quick Swap; The A250 one aligns using pins to fall into th…

---

_[View the full topic](https://forum.snapmaker.com/t/preset-save-in-software-laser/5313)._
