Hello.
I just ran the new 10w laser calibration on my new A350 machine.
The last step is the photo capture test where it cuts a square on a sheet
of A4 paper. It cut a nice square, but each side of the square has a short section
that was not lasered through. Is this normal? They look like they could be tabs
to hold the square in place.
All the calibration tests were successful according to on-screen prompts.
Any feedback would be welcomed. Thank you.
Redcedar
You can repeat it if you’re ever not happy, there’s a section for the 10W laser under the touchscreen Settings page, it has camera calibration etc there.