# Nozzle height calibration? Is this even necessary?

**URL:** <https://forum.snapmaker.com/t/nozzle-height-calibration-is-this-even-necessary/40953>\
**Category:** U1 Toolchanger\
**Created:** [January 14, 2026, 10:56pm UTC](https://forum.snapmaker.com/t/nozzle-height-calibration-is-this-even-necessary/40953 "2026-01-14T22:56:58Z")\
**Posts on this page:** 1\
**Showing post:** 4

<div class="post-metadata">

**Author:** ![Simon\_Zhi](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.snapmaker.com/simon_zhi/32/30470_2.png) [@Simon\_Zhi](https://forum.snapmaker.com/u/Simon_Zhi)\
**Post date:** [January 16, 2026, 3:29pm UTC](https://forum.snapmaker.com/t/nozzle-height-calibration-is-this-even-necessary/40953/4 "2026-01-16T15:29:48Z")

</div>

> [@Extruder nozzle grinding into prints](https://forum.snapmaker.com/t/extruder-nozzle-grinding-into-prints/40760/21):
>
> I remember the knobs under the heated bed are quite tight; they’re usually only used when you need to perform bed leveling. But the bed is usually leveled one time at the factory before shipping.But I don’t think this is what’s causing your issue. Still, I’ll add the steps just in case. After the bed is mechanically leveled, you normally only need the software-level compensation from now on (see image) and won’t touch the mechanical knobs again. before mechanically leveled start ，yo…

We still keep the mechanical (manual-assisted) bed-leveling option—follow this workflow when needed. Auto-leveling is purely software compensation on top of that mechanical baseline; you can choose whether to run it each time you send a print.

---

_[View the full topic](https://forum.snapmaker.com/t/nozzle-height-calibration-is-this-even-necessary/40953)._
