# New quick toolhead change print

**URL:** <https://forum.snapmaker.com/t/new-quick-toolhead-change-print/12740>\
**Category:** Snapmaker 2.0 (3-in-1)\
**Created:** [December 15, 2020, 9:29pm UTC](https://forum.snapmaker.com/t/new-quick-toolhead-change-print/12740 "2020-12-15T21:29:53Z")\
**Posts on this page:** 1\
**Showing post:** 15

<div class="post-metadata">

**Author:** ![brent113](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.snapmaker.com/brent113/32/11114_2.png) [@brent113](https://forum.snapmaker.com/u/brent113)\
**Post date:** [December 17, 2020, 2:19am UTC](https://forum.snapmaker.com/t/new-quick-toolhead-change-print/12740/15 "2020-12-17T02:19:37Z")

</div>

I think a clamping system would work. A ball stud (or something) that mates with a special clamp after it’s inserted.

Something like this for the stud, although I’m aware there’s very little clearance. The ball end would have to be smaller than opening, around 4.1mm.

 ![image](https://us1.discourse-cdn.com/flex022/uploads/snapmaker/original/2X/a/a3e3fa35be313a19d15ade20235a93d2185758cb.jpeg)

A specially designed clamp could slip over the top and bottom and tension against the stud  
 ![image](https://us1.discourse-cdn.com/flex022/uploads/snapmaker/original/2X/9/987ea6ff3a29dd754c29f0d9dfa377d827f2b749.png)

There’s a few obvious problems, but I think they would be easy enough to overcome. Like, what secures the clamp in place, how much tension is required, etc.

---

_[View the full topic](https://forum.snapmaker.com/t/new-quick-toolhead-change-print/12740)._