Manual support block

I want to add a base using the manual support option.

Ive tried using the move option but been unable to stop the model from aligning with the base plate.

However I want the model bottom to be higher than the base plate but inside the support block

Is this possible?

If you just want a base that’s present during printing and will be removed afterwards, try the “raft” bed adhesion type. Keep in mind that this will leave the underside of your object as rough as any other type of supports.

If that isn’t sufficient, try another slicer (or a CAD program, if you want a permanent base).

the trouble with raft is you cant specify the thickness or length.

consequently only a very small area of the bottom of the model is supported by the raft

ps the base is just for upright support during printing and is waste

Use meshlab or meshmixer to add the base to your model?

-S