# Layer shifts, need help **URL:** \ **Category:** Original (3-in-1)\ **Created:** [December 5, 2019, 10:30pm UTC](https://forum.snapmaker.com/t/layer-shifts-need-help/4716 "2019-12-05T22:30:33Z")\ **Posts on this page:** 1\ **Showing post:** 4
**Author:** ![clewis](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.snapmaker.com/clewis/32/3255_2.png) [@clewis](https://forum.snapmaker.com/u/clewis)\ **Post date:** [December 6, 2019, 6:25pm UTC](https://forum.snapmaker.com/t/layer-shifts-need-help/4716/4 "2019-12-06T18:25:32Z")
Regarding speed, I copied the 3 default print qualities in SnapmakerJS to Cura, and generally print Normal or High. I’ve also added two more settings, Ultra-High and Prototype. Ultra-High prints at the same speed as High Quality, but with a 0.05mm layer (the smallest allowed by Snapmaker). Prototype prints a 0.2mm layer, and all of the non-initial-layer speeds set to 80 mm/s. I most use Prototype when I’m designing models, and need to verify that I measured correctly. Just to double check, did you follow the instructions for [setting up Snapmaker](http://forum.snapmaker.com/t/generic-cura-profile/3236/2) in Cura? I don’t know GCode very well, but I think the extra GCode is just to prime the nozzle. So I don’t think it’s strictly required, but should help get a good initial layer down. I would like to hear your results. I haven’t had any issues switching between SnapmakerJS and Cura, but I have been considering OctoPi. --- _[View the full topic](https://forum.snapmaker.com/t/layer-shifts-need-help/4716)._