Hi everyone,
I have been trying to work with paper, 160g/m2.
Can anyone explain why the laser cuts through on the vertical sides quite irrelevantly of my settings ?
And also why the bottom of the square is not burnt correctly ? could this have to do with Luban 3.9?
Kindly,
Phil
Just a guess, the bottom might be a focus issue. The sides maybe because the tool is dwelling too long during a direction change.
I think the usual recommendation is to experiment with faster speeds.
Thanks Brent113 !!!
As the square is a vector i have no control over the dwell time, I will continue trying out as you suggest.
Please update if you make any progress, this is something I don’t have much experience in and would like to know if you got it to work and what you did!
