# Idea for quick switch bed: feedback requested **URL:** \ **Category:** Snapmaker 2.0 (3-in-1)\ **Created:** [January 4, 2021, 8:42pm UTC](https://forum.snapmaker.com/t/idea-for-quick-switch-bed-feedback-requested/13937 "2021-01-04T20:42:29Z")\ **Posts on this page:** 1\ **Showing post:** 50
**Author:** ![brvdboss](https://avatars.discourse-cdn.com/v4/letter/b/9f8e36/32.png) [@brvdboss](https://forum.snapmaker.com/u/brvdboss)\ **Post date:** [April 20, 2021, 7:16am UTC](https://forum.snapmaker.com/t/idea-for-quick-switch-bed-feedback-requested/13937/50 "2021-04-20T07:16:02Z")
Apart from what was already mentioned, there also this simpler solution, yet less structural than the already mentioned solutions: > [@Bed too flinsy for a CNC face operation?](https://forum.snapmaker.com/t/bed-too-flinsy-for-a-cnc-face-operation/16101/11): > > I’ve designed and printed a small sliding support that clips on the underside of the base and floats 0.2mm above the actuator (see dark blue piece). When there is downward pressure it will contact the actuator and limit the vertical movement of the bed. If you make 4 of them (2 of each side) and install them in the front and back you will get containment in both directions. Here is a link to the geometry in thingiverse: [Snapmaker A250 Sliding Support by ppmendonca - Thingiverse](https://www.thingiverse.com/thing:4779318). It’s still a w… > **[Snapmaker A250 Sliding Support by ppmendonca](https://www.thingiverse.com/thing:4779318)** > > This sliding support clips on the underside of the Snapmaker A250 base to limit vertical movement by contacting the actuator below it. > You will need 2 of these and 2 of the mirror of these (1 for each corner of the bed). --- _[View the full topic](https://forum.snapmaker.com/t/idea-for-quick-switch-bed-feedback-requested/13937)._