# Has anyone else had problems with the hand held controller at high temperature?

**URL:** <https://forum.snapmaker.com/t/has-anyone-else-had-problems-with-the-hand-held-controller-at-high-temperature/12424>\
**Category:** Original (3-in-1)\
**Created:** [December 8, 2020, 9:20am UTC](https://forum.snapmaker.com/t/has-anyone-else-had-problems-with-the-hand-held-controller-at-high-temperature/12424 "2020-12-08T09:20:03Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![CEN888](https://avatars.discourse-cdn.com/v4/letter/c/c2a13f/32.png) [@CEN888](https://forum.snapmaker.com/u/CEN888)\
**Post date:** [December 8, 2020, 9:20am UTC](https://forum.snapmaker.com/t/has-anyone-else-had-problems-with-the-hand-held-controller-at-high-temperature/12424/1 "2020-12-08T09:20:03Z")

</div>

I only received my Snapmaker a few days ago along with the enclosure . I had done a couple of successful PLA prints inside with the aircon ~ 23 Deg C and no enclosure . I moved the printer to the garage and installed the enclosure . Ambient temperature around 34 Deg C , enclosure closed . After a few successful layers being printed , all three axis’s traveled to maximum and the filament began to spew out in mid air. I then ran the controller cable outside the enclosure and left a small fan pushing air across it . The print then ran through successfully to the end . Has anyone had issues like this when the controller gets hot ?