# Fusion 360 feed rate/speed **URL:** \ **Category:** Snapmaker2.0 Troubleshooting guides\ **Created:** [March 22, 2021, 4:43am UTC](https://forum.snapmaker.com/t/fusion-360-feed-rate-speed/17190 "2021-03-22T04:43:32Z")\ **Posts on this page:** 1\ **Showing post:** 4
**Author:** ![brvdboss](https://avatars.discourse-cdn.com/v4/letter/b/9f8e36/32.png) [@brvdboss](https://forum.snapmaker.com/u/brvdboss)\ **Post date:** [March 22, 2021, 1:17pm UTC](https://forum.snapmaker.com/t/fusion-360-feed-rate-speed/17190/4 "2021-03-22T13:17:22Z")
The original went up to 19000rpm. Typically, less powerful spindles have higher rpm. It compensates for the lower torque of the spindle. (that’s why tools like dremel etc also go up to 30000rpm for example) apart from that, this topic also covers a lot of useful info on CNC (and laser): > [@Some info on cnc tool changes and combo cnc/laser projects](https://forum.snapmaker.com/t/some-info-on-cnc-tool-changes-and-combo-cnc-laser-projects/14102): > > @brent113 asked me a few questions about my process for cnc & laser. It was in response to some of the pieces I’d posted in this thread: [Multi tool projects](https://forum.snapmaker.com/t/multi-tool-projects/9644) We thought it would probably be good to share some of my answers and methods and some tips. Hopefully it will be helpful. This information should probably be considered intermediate to advanced. At some point I may make a guide to using Fusion 360 with svg’s and creating tool paths, and also using Easel by Inventables, but this assumes you… --- _[View the full topic](https://forum.snapmaker.com/t/fusion-360-feed-rate-speed/17190)._