# Full Lightburn Control Guide

**URL:** <https://forum.snapmaker.com/t/full-lightburn-control-guide/27638>\
**Category:** Snapmaker 2.0 (3-in-1)\
**Created:** [October 23, 2022, 1:20am UTC](https://forum.snapmaker.com/t/full-lightburn-control-guide/27638 "2022-10-23T01:20:50Z")\
**Posts on this page:** 1\
**Showing post:** 161

<div class="post-metadata">

**Author:** ![Skreelink](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.snapmaker.com/skreelink/32/16398_2.png) [@Skreelink](https://forum.snapmaker.com/u/Skreelink)\
**Post date:** [March 12, 2023, 9:52pm UTC](https://forum.snapmaker.com/t/full-lightburn-control-guide/27638/161 "2023-03-12T21:52:43Z")

</div>

I ran yours and actually had the same problem, really befuddling me.

…then omfg. Apparently something in the recent changes does _something_, I don’t know what, with how it reads comments. All I did was remove the space before, and everything after and including the `;` in your header and footer, and it ran correctly. Reverted the change to have the comments back in; it began running high again. Snapmaker; the hell?

So yeah in your lightburn config, try using this header (added a G90 for safety after the homing):

```auto
M106 P0 S255
G28
G90
G53
G0 Z30.6 F6000
G54
G92 Z0
G0 Z300
G53
G0 X0 Y0 F6000
G54
G92 X0 Y0
M3 S0

```

and footer;

```auto
M5
G0 Z330 F6000
G0 Y350
G28

```

NOTE TO EVERYONE ELSE, REMOVE MY NOTES FROM YOUR HEADER. 😕

---

_[View the full topic](https://forum.snapmaker.com/t/full-lightburn-control-guide/27638)._