# Extruder Calibration a must **URL:** \ **Category:** Snapmaker 2.0 (3-in-1)\ **Created:** [July 16, 2020, 7:51pm UTC](https://forum.snapmaker.com/t/extruder-calibration-a-must/7724 "2020-07-16T19:51:11Z")\ **Posts on this page:** 1\ **Showing post:** 185
**Author:** ![sdj544](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.snapmaker.com/sdj544/32/11365_2.png) [@sdj544](https://forum.snapmaker.com/u/sdj544)\ **Post date:** [April 20, 2021, 5:41pm UTC](https://forum.snapmaker.com/t/extruder-calibration-a-must/7724/185 "2021-04-20T17:41:39Z")
> [@MattSlay](#): > > This forum message titled “Extruder Calibration a Must” was started July 2020 and it now has over 180 replies of discussions spanning over 10 months of time. Am I really supposed to dig out the required steps from this massive payload of chatting? I created a summary of the information contained here: > [@Summary: Extruder calibration a must](https://forum.snapmaker.com/t/summary-extruder-calibration-a-must/16667): > > The topic known as: has become very useful to point people to so that they can calibrate their e-steps. However, that topic has become a bit large and overwhelming for a newcomer. So I’m starting this topic as an easier alternative to refer people to. Please continue to use the original topic for any discussion or questions so that we can keep this thread lean & mean. Here are the steps for calibrating the extruder on a Snapmaker A150, A250, or A350: On the touchscreen, swipe left and tap … (I thought I’d posted a link in this document but it seems to have disappeared) -S --- _[View the full topic](https://forum.snapmaker.com/t/extruder-calibration-a-must/7724)._