# Discussion of Snapmaker 2.0 Firmware Updates **URL:** \ **Category:** Snapmaker 2.0 (3-in-1)\ **Created:** [February 27, 2020, 6:39am UTC](https://forum.snapmaker.com/t/discussion-of-snapmaker-2-0-firmware-updates/5441 "2020-02-27T06:39:15Z")\ **Posts on this page:** 1\ **Showing post:** 128
**Author:** ![Waldo](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.snapmaker.com/waldo/32/1704_2.png) [@Waldo](https://forum.snapmaker.com/u/Waldo)\ **Post date:** [May 21, 2020, 9:11pm UTC](https://forum.snapmaker.com/t/discussion-of-snapmaker-2-0-firmware-updates/5441/128 "2020-05-21T21:11:58Z")
I have not tried 1.8 yet, I’m a bit concerned about some bugs. But I would like to have CNC levelling implemented in the next firmware. Following is my implementation to achieve this. > [@Bed leveling for pcb milling?](https://forum.snapmaker.com/t/bed-leveling-for-pcb-milling/4579/28): > > @Mika, @Melanchrom, @Tone, @Edwin, @parachvte I’m pleased to announce that I have successfully leveled my Carving platform/Wasteboard. Can you please implement Manual Bed leveling for CNC in the next firmware? First, my CNC bed was 0.65mm lower at the back than the front, actually lower than the middle since the front and middle had the same offsets/measurements. I could not do a proper CNC engraving on acrylic. (same problem as milling on a PCB board) Following is my process; I followed … --- _[View the full topic](https://forum.snapmaker.com/t/discussion-of-snapmaker-2-0-firmware-updates/5441)._