# Cura 4.13 new 3D printer module new speed values

**URL:** <https://forum.snapmaker.com/t/cura-4-13-new-3d-printer-module-new-speed-values/23758>\
**Category:** Snapmaker 2.0 (3-in-1)\
**Created:** [January 20, 2022, 4:03am UTC](https://forum.snapmaker.com/t/cura-4-13-new-3d-printer-module-new-speed-values/23758 "2022-01-20T04:03:47Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Blauskink](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.snapmaker.com/blauskink/32/17834_2.png) [@Blauskink](https://forum.snapmaker.com/u/Blauskink)\
**Post date:** [January 20, 2022, 4:03am UTC](https://forum.snapmaker.com/t/cura-4-13-new-3d-printer-module-new-speed-values/23758/1 "2022-01-20T04:03:47Z")

</div>

Hello Snapmaker friends Snapmaker team,  
I bought the Snapmaker A350T, in this is yes the new 3D printer module included.  
Here now my question:  
In the new set is yes the revised 3D printer module included, I work with Cura 4.13. Are the speed values when selecting Cura 4.13 of the printer Snapmaker 2 A350 already the speed values for the current 3D printer module or still for the old !  
How fast or how high can I set the values of the speed in the software maximum!  
Is there from Snapmaker data guide values !?  
Attached is a picture of the current Cura 4.13 profile with the speed data.  
Greetings Reiner  
 ![Snapmaker Geschwindigkeitswerte](https://us1.discourse-cdn.com/flex022/uploads/snapmaker/original/3X/d/5/d5c059389d9c520f7a9092e5c77bf4bfa8ad9813.jpeg)

---

<div class="post-metadata">

**Author:** ![clewis](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.snapmaker.com/clewis/32/3255_2.png) [@clewis](https://forum.snapmaker.com/u/clewis)\
**Post date:** [January 20, 2022, 5:56pm UTC](https://forum.snapmaker.com/t/cura-4-13-new-3d-printer-module-new-speed-values/23758/2 "2022-01-20T17:56:00Z")

</div>

When I created my Cura profiles, I copied the speeds from Luban. Fast mode prints an initial layer at 18 mm/s, wall at 60 mm/s, and travels at 70 mm/s. High Quality mode prints the initial layer at 18 mm/s, walls at 20 mm/s, and travels at 40 mm/s.

I don’t read German, but based on the layout, those speeds look somewhere between the Normal or Fast profile that Luban has. I don’t see any problem with them.

I have a v1. I found that if I go over 80 mm/s, the lead screws will skip a thread and shift layers. I recall seeing a post where somebody was pushing their v2 to 120 mm/s, but I haven’t seen any followup results.