# Cura 1.5.0 for slicing

**URL:** https://forum.snapmaker.com/t/cura-1-5-0-for-slicing/25097
**Category:** Snapmaker Luban
**Created:** [March 31, 2022, 6:48pm UTC](https://forum.snapmaker.com/t/cura-1-5-0-for-slicing/25097 "2022-03-31T18:48:21Z")
**Posts on this page:** 1
**Showing post:** 2

<div class="post-metadata">

### Author: ![brent113](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.snapmaker.com/brent113/32/11114_2.png) [@brent113](https://forum.snapmaker.com/u/brent113)
#### Post date: [March 31, 2022, 7:08pm UTC](https://forum.snapmaker.com/t/cura-1-5-0-for-slicing/25097/2 "2022-03-31T19:08:00Z")

</div>

Maybe start with these

> [@Profiles for Snapmaker 2.0](https://forum.snapmaker.com/t/profiles-for-snapmaker-2-0/5624):
>
> Hi all, Attached are the Cura and Simplify3D profiles for the Snapmaker 2.0. Please refer to the following article on our website for specific settings. Thank you. [Cura Profiles.zip](https://forum.snapmaker.com/uploads/short-url/v5aZMGBmQ1W8AgMDsFSJM5PL3AY.zip) (2.9 KB) [Simplify3D Profiles.zip](https://forum.snapmaker.com/uploads/short-url/8RJoDpCcYPV3CuKey1D6sTBki08.zip) (8.3 KB)

Personally I don’t care for the start and end gcode they use, you should consider tweaking it. If you look around many people have posted their start/end codes they use.

Something like this: [Cura not honoring initial layer temperatures when printing on A350 - #7 by MooseJuice](https://forum.snapmaker.com/t/cura-not-honoring-initial-layer-temperatures-when-printing-on-a350/11202/7)

---

_[View the full topic](https://forum.snapmaker.com/t/cura-1-5-0-for-slicing/25097)._