# Cross line laser

**URL:** <https://forum.snapmaker.com/t/cross-line-laser/34846>\
**Category:** Ray (Laser)\
**Created:** [February 8, 2024, 6:33pm UTC](https://forum.snapmaker.com/t/cross-line-laser/34846 "2024-02-08T18:33:58Z")\
**Posts on this page:** 1\
**Showing post:** 2

<div class="post-metadata">

**Author:** ![xchrisd](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.snapmaker.com/xchrisd/32/1503_2.png) [@xchrisd](https://forum.snapmaker.com/u/xchrisd)\
**Post date:** [February 8, 2024, 7:02pm UTC](https://forum.snapmaker.com/t/cross-line-laser/34846/2 "2024-02-08T19:02:22Z")

</div>

[https://wiki.snapmaker.com/en/snapmaker\_ray/troubleshooting/crosshair\_offset](https://wiki.snapmaker.com/en/snapmaker_ray/troubleshooting/crosshair_offset)

> [@Using Artisan with LightBurn](https://forum.snapmaker.com/t/using-artisan-with-lightburn/34513/3):
>
> Reading the lines of the settings, they’re all setup as GRBL machines. The 2.0 and Artisan run on Marlin, the Ray is GRBL. I’m going by the 40W on all three for the analysis. 2.0; "StartGCode": ";header\_type: laser\n;machine: sm2\n;gcode\_flavor: grbl\n;renderMethod: line\n;max\_power: 255", Artisan; "StartGCode": ";header\_type: laser\n;machine: artisan\n;gcode\_flavor: grbl\n;renderMethod: line\n;max\_power: 255", Ray; "StartGCode": ";header\_type: laser\n;machine: Ray\n;gcode\_flavor: grbl\n;r…

---

_[View the full topic](https://forum.snapmaker.com/t/cross-line-laser/34846)._