# CNC Rotary Module - Origin problem

**URL:** <https://forum.snapmaker.com/t/cnc-rotary-module-origin-problem/24113>\
**Category:** Snapmaker 2.0 (3-in-1)\
**Created:** [February 4, 2022, 11:41pm UTC](https://forum.snapmaker.com/t/cnc-rotary-module-origin-problem/24113 "2022-02-04T23:41:44Z")\
**Posts on this page:** 1\
**Showing post:** 4

<div class="post-metadata">

**Author:** ![Wyphorn](https://avatars.discourse-cdn.com/v4/letter/w/ebca7d/32.png) [@Wyphorn](https://forum.snapmaker.com/u/Wyphorn)\
**Post date:** [February 5, 2022, 3:22pm UTC](https://forum.snapmaker.com/t/cnc-rotary-module-origin-problem/24113/4 "2022-02-05T15:22:35Z")

</div>

I used the origin assistant and later also the manual set x/y/z/b inside the run assistant.  
The problem is not the defining of the part. I want just to define a different start point. Not the tailstock center.

I think it is equal to this: [When setting the work origin - #2 by albutch](https://forum.snapmaker.com/t/when-setting-the-work-origin/24081/2)

I configured the piece now 5cm longer and set the origin to a virtual center point 5cm in front of the piece. And now it works. But it is a dirty hack and no solution.

---

_[View the full topic](https://forum.snapmaker.com/t/cnc-rotary-module-origin-problem/24113)._
