# CNC mode, z axis levelling **URL:** \ **Category:** Snapmaker 2.0 (3-in-1)\ **Created:** [January 25, 2023, 10:10am UTC](https://forum.snapmaker.com/t/cnc-mode-z-axis-levelling/29276 "2023-01-25T10:10:17Z")\ **Posts on this page:** 1\ **Showing post:** 2
**Author:** ![xchrisd](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.snapmaker.com/xchrisd/32/1503_2.png) [@xchrisd](https://forum.snapmaker.com/u/xchrisd)\ **Post date:** [January 26, 2023, 7:30pm UTC](https://forum.snapmaker.com/t/cnc-mode-z-axis-levelling/29276/2 "2023-01-26T19:30:10Z")
This is what you are looking for, unfortunately its no ready to run solution: > [@Tutorial on Flat Milling the Wasteboard](https://forum.snapmaker.com/t/tutorial-on-flat-milling-the-wasteboard/20518): > > Hey guys, I spent quite a bit of time trying to figure out how to level my CNC bed. I was under the assumption that it would come levelled or there would be some auto-levelling mechanism, but there isn’t. I went through a few failed jobs before finally deciding I needed to figure out how to level my bed. Since I spent a day getting this to work, I figured I would document it for anyone else who might be facing the same issues as me. I have the [step by step tutorial with pictures here](https://chaijiaxun.com/levelling-the-snapmaker-cnc-bed/), but here’… > [@Autoleveling and CNC journey](https://forum.snapmaker.com/t/autoleveling-and-cnc-journey/5927): > > I decided to add autoleveling to snapmaker for cnc, I don’t have a problem milling pcbs but I would like to make the process easier. Right now I can mill a board in 1 shot correctly, but it’s slow and loud due to having to move at 6% speed, I’ve attached a picture of the results below: This is a good result but it could be better, namely if there was autoleveling, I could move faster and also use isolation routing. Based off Lubans source code I’m trying to figure … --- _[View the full topic](https://forum.snapmaker.com/t/cnc-mode-z-axis-levelling/29276)._