CNC carving depth?


Hi, I’m about to finally carve something on this afternoon, and I was studying in advance on how to proceed. One thing I didn’t find is where do I set the depth of my cut?

I understand that Black is a full cut, and white are non-cuts and that grey areas in between will have different depths. But how do you set the 100% “black depth” of the carving file? Or is it a standard fixed depth? Is so, how much?

Thanks in advance!


There is a “Target Depth” on the right side configuration of your SVG file, setting it to some depth you would like to move your bit to.


Thanks a lot! I should’ve know that the specs only appear once you load the image :smiley: