# Calibration pushing deep into buildplate

**URL:** <https://forum.snapmaker.com/t/calibration-pushing-deep-into-buildplate/4972>\
**Category:** Snapmaker 2.0 (3-in-1)\
**Created:** [January 17, 2020, 3:55pm UTC](https://forum.snapmaker.com/t/calibration-pushing-deep-into-buildplate/4972 "2020-01-17T15:55:15Z")\
**Posts on this page:** 1\
**Showing post:** 55

<div class="post-metadata">

**Author:** ![moonglum](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.snapmaker.com/moonglum/32/2846_2.png) [@moonglum](https://forum.snapmaker.com/u/moonglum)\
**Post date:** [March 4, 2020, 2:39pm UTC](https://forum.snapmaker.com/t/calibration-pushing-deep-into-buildplate/4972/55 "2020-03-04T14:39:44Z")

</div>

Oh! I got you now. Yes, I could see how that would be helpful… Thanks!

btw, I did hear from snapmaker. Apparently there is another thread out there that addresses a similar issue, but didn’t come up when I searched. There are some suggested procedures there. I’ll be tackling this this weekend. Between the suggestions here and in that thread, I feel well equipped to do this.

Thanks gain.

-mg

The other thread: [Snapmaker official response to print head gouging?](https://forum.snapmaker.com/t/snapmaker-official-response-to-print-head-gouging/5248/4)

---

_[View the full topic](https://forum.snapmaker.com/t/calibration-pushing-deep-into-buildplate/4972)._