# Calibration data lost

**URL:** <https://forum.snapmaker.com/t/calibration-data-lost/27373>\
**Category:** Snapmaker 2.0 (3-in-1)\
**Created:** [September 24, 2022, 2:33pm UTC](https://forum.snapmaker.com/t/calibration-data-lost/27373 "2022-09-24T14:33:02Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![polrus](https://avatars.discourse-cdn.com/v4/letter/p/3d9bf3/32.png) [@polrus](https://forum.snapmaker.com/u/polrus)\
**Post date:** [September 24, 2022, 2:33pm UTC](https://forum.snapmaker.com/t/calibration-data-lost/27373/1 "2022-09-24T14:33:02Z")

</div>

Hi recently my snapmaker too started to behave in a strange way basically it loses calibration data.

I put the machine I go through five-step calibration until the end.

Everything looks fine i am taken to the home page on the touchpad.

Ten as lect File from USB pendrive and try to printe but then I get the message  
“The machine hasn’t detected any calibration data”

I try to do the same but reboot/power-cycle after the calibration. After fresh start intry to print and I still get the same message.

I’ve ever had any problems with previous versions of firmware - now I’m using the current one v1.14.3\_20220617
