Hi Snapmaker Team,
I’ve currently some issues with the current version of firmware (GD32Base 2.7). Since I’ve updated my Snapmaker to this firmware version, I’m facing issues with calibration. Usually, after an update, I needed to re-calibrate the device. But with this version, calibration is not possible anymore because of wrong positioning of the printer module. If I choose calibration position 1 the printer module will move too far left from the heating bed (around 10mm), so if try to lower the z-level the nozzle will fail to touch the heating bed.
I’ve noticed this issue even with version 2.6. But if I downgrade to version 2.5 it works fine again. So there must be a problem with the firmware version 2.6 and 2.7.