# Autoleveling not saving the calibration Z-offset

**URL:** <https://forum.snapmaker.com/t/autoleveling-not-saving-the-calibration-z-offset/20655>\
**Category:** Snapmaker 2.0 (3-in-1)\
**Created:** [August 30, 2021, 12:46am UTC](https://forum.snapmaker.com/t/autoleveling-not-saving-the-calibration-z-offset/20655 "2021-08-30T00:46:32Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![punk\_bastard](https://avatars.discourse-cdn.com/v4/letter/p/b9e5f3/32.png) [@punk\_bastard](https://forum.snapmaker.com/u/punk_bastard)\
**Post date:** [August 30, 2021, 12:46am UTC](https://forum.snapmaker.com/t/autoleveling-not-saving-the-calibration-z-offset/20655/1 "2021-08-30T00:46:32Z")

</div>

Everytime I autolevel the printer seems to not “remember” the offset saved during autolevel.

Printer is a 350 with firmware1.13. I adjusted leveling sensor to 1mm above the nozzle. I tested the ABL with a knife and it stopped. I am about to try and do a factory reset to see if that helps. Any suggestions on how to solve this would be great.

I need an easy method of leveling since I print in 3-4 different materials.

---

<div class="post-metadata">

**Author:** ![CNC-Maker](https://avatars.discourse-cdn.com/v4/letter/c/df788c/32.png) [@CNC-Maker](https://forum.snapmaker.com/u/CNC-Maker)\
**Post date:** [August 30, 2021, 5:47am UTC](https://forum.snapmaker.com/t/autoleveling-not-saving-the-calibration-z-offset/20655/2 "2021-08-30T05:47:21Z")

</div>

When you perform a level, you are also required to set a Z Offset. It is not supposed to remember any Z Offset, because it is reset when you perform a level.